TrippLite SMART700HG
Details
Tripp Lite's SMART700HG offers medical-grade UPS protection with built-in line interactive voltage regulation, intelligent monitoring and unattended shutdown capability.
UL2601-1 listed as medical electrical equipment with less than 300 microamps leakage current for the UPS and all connected equipment. Built-in isolation transformer with faraday shield removes common mode noise while maintaining full AC surge suppression in all modes.
Includes high quality hospital-grade plug and outlets. 700VA power handling capacity supports computers, internetworking equipment and other critical loads during commercial power failures. Line interactive voltage regulation corrects brownouts as low as 81V and overvoltages as high as 143 back to normal 120V levels, saving battery reserves for use only during complete power failures.
Includes 4 outlets, diagnostic LEDs and built-in USB & RS-232 communications ports that work with downloadable PowerAlert Software and cabling to provide automatic unattended shutdown of connected network and PC applications.
OUTPUT | |
---|---|
Output Volt Amp Capacity (VA) | 700 |
Output Watt Capacity (Watts) | 450 |
Power Factor | 0.6 |
Nominal Output Voltage(s) Supported | 115V; 120V |
Frequency Compatibility | 60 Hz |
Output Voltage Regulation (Line Mode) | -18%, +8% |
Output Voltage Regulation (Battery Mode) | 115V (+/- 5%) |
Output Receptacles | (4) 5-15R |
Output Receptacle Details | Hospital grade output receptacles |
Output AC Waveform (AC Mode) | Sine wave |
Output AC Waveform (Battery Mode) | PWM sine wave |
INPUT | |
---|---|
Rated input current (Maximum Load) | 5.5A |
Nominal Input Voltage(s) Supported | 120V AC |
UPS Input Connection Type | 5-15P-HG |
Input Circuit Breakers | 10A |
UPS Input Cord Length (ft.) | 6 |
UPS Input Cord Length (m) | 1.8 |
Recommended Electrical Service | 15A 120V |
Input Cord Length (ft.) | 6 |
Input Cord Length (m) | 1.8 |
Input Phase | Single-Phase |
BATTERY | |
---|---|
Full Load Runtime (min.) | 18 min. (450w) |
Half Load Runtime (min.) | 42 min. (225w) |
DC System Voltage (VDC) | 36 |
Battery Recharge Rate (Included Batteries) | Less than 4 hours from 10% to 90% |
-
Francesco Warner review Review by Francesco Warner
Rating You shipped the came in no time at all to Brea, California. Thanks for the quick help! (Posted on 5/6/2019)
WRITE YOUR REVIEW
Write Your Own Review
Features
Details
Tripp Lite's SMART700HG offers medical-grade UPS protection with built-in line interactive voltage regulation, intelligent monitoring and unattended shutdown capability.
UL2601-1 listed as medical electrical equipment with less than 300 microamps leakage current for the UPS and all connected equipment. Built-in isolation transformer with faraday shield removes common mode noise while maintaining full AC surge suppression in all modes.
Includes high quality hospital-grade plug and outlets. 700VA power handling capacity supports computers, internetworking equipment and other critical loads during commercial power failures. Line interactive voltage regulation corrects brownouts as low as 81V and overvoltages as high as 143 back to normal 120V levels, saving battery reserves for use only during complete power failures.
Includes 4 outlets, diagnostic LEDs and built-in USB & RS-232 communications ports that work with downloadable PowerAlert Software and cabling to provide automatic unattended shutdown of connected network and PC applications.
OUTPUT | |
---|---|
Output Volt Amp Capacity (VA) | 700 |
Output Watt Capacity (Watts) | 450 |
Power Factor | 0.6 |
Nominal Output Voltage(s) Supported | 115V; 120V |
Frequency Compatibility | 60 Hz |
Output Voltage Regulation (Line Mode) | -18%, +8% |
Output Voltage Regulation (Battery Mode) | 115V (+/- 5%) |
Output Receptacles | (4) 5-15R |
Output Receptacle Details | Hospital grade output receptacles |
Output AC Waveform (AC Mode) | Sine wave |
Output AC Waveform (Battery Mode) | PWM sine wave |
INPUT | |
---|---|
Rated input current (Maximum Load) | 5.5A |
Nominal Input Voltage(s) Supported | 120V AC |
UPS Input Connection Type | 5-15P-HG |
Input Circuit Breakers | 10A |
UPS Input Cord Length (ft.) | 6 |
UPS Input Cord Length (m) | 1.8 |
Recommended Electrical Service | 15A 120V |
Input Cord Length (ft.) | 6 |
Input Cord Length (m) | 1.8 |
Input Phase | Single-Phase |
BATTERY | |
---|---|
Full Load Runtime (min.) | 18 min. (450w) |
Half Load Runtime (min.) | 42 min. (225w) |
DC System Voltage (VDC) | 36 |
Battery Recharge Rate (Included Batteries) | Less than 4 hours from 10% to 90% |
Reviews
-
Francesco Warner review Review by Francesco Warner
Rating You shipped the came in no time at all to Brea, California. Thanks for the quick help! (Posted on 5/6/2019)