TrippLite SMART2200VS
Details
Tripp Lite's SMART 2200VS intelligent, line interactive UPS protects server, networking and telecommunications equipment from blackouts, voltage fluctuations and transient surges.
Small footprint, tower UPS system occupies only 106 square inches of floorspace with a height of only 14.25 inches.
Large capacity 2200 VA / 1600 watt rated UPS system offers 7 minutes runtime at full load and 19 minutes at half load during power failures. Line interactive voltage regulation corrects brownouts as low as 79V and overvoltages as high as 147V to fully regulated 120V nominal output for smooth continuous operation of connected equipment. Includes a total of 9 outlets, 3 pairs of which can be individually powered off and back on via software interface to selectively reboot remote equipment or shed less critical loads to extend battery runtime for more critical loads.
Includes slot for internal SNMPWEBCARD, plus 2 DB9 and 2 USB enhanced monitoring ports for unattended shutdown, remote control and monitoring of UPS system and power data. Ships in attractive gray color scheme.
Compatible with Tripp Lite's PowerAlert and Watchdog service software.
OUTPUT | |
|---|---|
| Output Volt Amp Capacity (VA) | 2200 |
| Output kVA Capacity (kVA) | 2.2 |
| Output Watt Capacity (Watts) | 1600 |
| Output kW Capacity (kW) | 1.6 |
| Power Factor | 0.7 |
| Nominal Output Voltage(s) Supported | 120V |
| Frequency Compatibility | 60 Hz |
| Output Voltage Regulation (Line Mode) | -18% / +8% |
| Output Voltage Regulation (Battery Mode) | +/- 5% |
| Output Receptacles | (7) 5-15R; (2) 5-15/20R |
| Load Management Receptacles | Three switchable two-outlet 5-15R load banks |
| Output AC Waveform (AC Mode) | Sine wave |
| Output AC Waveform (Battery Mode) | PWM sine wave |
INPUT | |
|---|---|
| Rated input current (Maximum Load) | 16A |
| Nominal Input Voltage(s) Supported | 120V AC |
| UPS Input Connection Type | 5-20P |
| Input Circuit Breakers | 20A |
| UPS Input Cord Length (ft.) | 8 |
| UPS Input Cord Length (m) | 2.4 |
| Recommended Electrical Service | 20A 120V |
| Input Phase | Single-Phase |
BATTERY | |
|---|---|
| Full Load Runtime (min.) | 7 min. (1600w) |
| Half Load Runtime (min.) | 19 min. (800w) |
| DC System Voltage (VDC) | 48 |
| Battery Recharge Rate (Included Batteries) | Less than 4 hours from 10% to 90% (typical, full load discharge) |
-
Buddy Dawson review Review by Buddy Dawson
Rating My company needed the and got to Holly Springs, Mississippi faster than I ever expected. Very helpful. (Posted on 5/6/2019)
WRITE YOUR REVIEW
Write Your Own Review
Features
Details
Tripp Lite's SMART 2200VS intelligent, line interactive UPS protects server, networking and telecommunications equipment from blackouts, voltage fluctuations and transient surges.
Small footprint, tower UPS system occupies only 106 square inches of floorspace with a height of only 14.25 inches.
Large capacity 2200 VA / 1600 watt rated UPS system offers 7 minutes runtime at full load and 19 minutes at half load during power failures. Line interactive voltage regulation corrects brownouts as low as 79V and overvoltages as high as 147V to fully regulated 120V nominal output for smooth continuous operation of connected equipment. Includes a total of 9 outlets, 3 pairs of which can be individually powered off and back on via software interface to selectively reboot remote equipment or shed less critical loads to extend battery runtime for more critical loads.
Includes slot for internal SNMPWEBCARD, plus 2 DB9 and 2 USB enhanced monitoring ports for unattended shutdown, remote control and monitoring of UPS system and power data. Ships in attractive gray color scheme.
Compatible with Tripp Lite's PowerAlert and Watchdog service software.
OUTPUT | |
|---|---|
| Output Volt Amp Capacity (VA) | 2200 |
| Output kVA Capacity (kVA) | 2.2 |
| Output Watt Capacity (Watts) | 1600 |
| Output kW Capacity (kW) | 1.6 |
| Power Factor | 0.7 |
| Nominal Output Voltage(s) Supported | 120V |
| Frequency Compatibility | 60 Hz |
| Output Voltage Regulation (Line Mode) | -18% / +8% |
| Output Voltage Regulation (Battery Mode) | +/- 5% |
| Output Receptacles | (7) 5-15R; (2) 5-15/20R |
| Load Management Receptacles | Three switchable two-outlet 5-15R load banks |
| Output AC Waveform (AC Mode) | Sine wave |
| Output AC Waveform (Battery Mode) | PWM sine wave |
INPUT | |
|---|---|
| Rated input current (Maximum Load) | 16A |
| Nominal Input Voltage(s) Supported | 120V AC |
| UPS Input Connection Type | 5-20P |
| Input Circuit Breakers | 20A |
| UPS Input Cord Length (ft.) | 8 |
| UPS Input Cord Length (m) | 2.4 |
| Recommended Electrical Service | 20A 120V |
| Input Phase | Single-Phase |
BATTERY | |
|---|---|
| Full Load Runtime (min.) | 7 min. (1600w) |
| Half Load Runtime (min.) | 19 min. (800w) |
| DC System Voltage (VDC) | 48 |
| Battery Recharge Rate (Included Batteries) | Less than 4 hours from 10% to 90% (typical, full load discharge) |
Reviews
-
Buddy Dawson review Review by Buddy Dawson
Rating My company needed the and got to Holly Springs, Mississippi faster than I ever expected. Very helpful. (Posted on 5/6/2019)
WRITE YOUR REVIEW
Write Your Own Review
© 2008 - 2020 iBuy Stores, Inc. All Rights Reserved.
Due to Prop 65 restrictions, we have a selected product offering to the state of CA at this time. As we get additional compliance confirmations from our manufacturers we will feature more product lines for availability. Contact us for more information. ⚠ WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.govWe Accept
